The short version of lyophilized powder fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-12-04 and is reviewed periodically as new material appears.
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
| Property | Value | Notes |
|---|---|---|
| Molecular mass | ≈889 Da for the 7-residue fragment | Full-length thymosin beta-4 is ≈4.9 kDa; catalogs differ |
| Appearance | White to off-white powder | Hygroscopic; weight shifts with residual moisture |
| Solubility class | Freely soluble in water | Also dissolves in aqueous buffers; poorly soluble in nonpolar solvents |
| Typical storage temperature | −20 °C, desiccated, protected from light | Once rehydrated, short-term holding at 2-8 °C |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Purity by UV absorbance; identity by ESI-MS or MALDI-TOF |
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Lyophilized peptide arrives as a dry cake that should stay sealed until use. Reconstitution is generally performed with sterile water or a buffered solution, and the resulting liquid should be handled gently to limit mechanical stress. Repeated freeze-thaw cycles are widely described as harmful to short peptides, so dividing a reconstituted batch into single-use portions is a common practice. Laboratories also record the solvent, concentration, and date of preparation on the vial label to keep later measurements traceable.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
Identity and purity are normally assessed with reversed-phase high-performance liquid chromatography, paired with mass spectrometry to confirm molecular mass. A certificate of analysis reports a purity percentage, usually derived from chromatographic peak area, but that figure does not by itself prove a correct sequence or the absence of counterions. Independent verification may include amino acid analysis or peptide mapping. Batch-to-batch variation is a documented concern in the research chemical market, and the gap between a quoted purity value and actual peptide content can be substantial when the material is a salt or retains residual water.
Material is normally supplied as a lyophilised powder in a sealed vial. The powder is hygroscopic, so exposure to humid air leads to water uptake, caking and gradual loss of the fluffy texture that indicates a good freeze-dry. Vials are best kept sealed with desiccant, protected from light and stored cold. Letting a cold vial warm to room temperature before opening reduces condensation on the contents. Purity is normally reported from a chromatographic run, and that figure applies to the batch as tested rather than to the vial after repeated opening.
Once dissolved, the peptide is far less stable than the dry powder. Aqueous solutions are subject to hydrolysis, oxidation at susceptible residues and gradual loss of material through adsorption onto glass and plastic surfaces. Terminal glutamine can cyclise under some conditions, producing a related species that complicates purity assessment. Dilute solutions tend to lose a larger fraction of material to surfaces than concentrated ones. Buffers, pH and ionic strength all influence the rate of change, so stability figures are only meaningful when those parameters are stated alongside the storage interval.
Detection in biological samples relies on mass spectrometry, typically liquid chromatography coupled to tandem mass spectrometry after peptide extraction and enrichment. Intact peptides can also be confirmed by high-resolution mass measurement together with fragmentation data. Detection windows in urine are short because the peptide is degraded by proteases and cleared quickly, and concentrations are low. Many jurisdictions treat the compound as a prohibited substance in sport, grouped with peptide hormones and related factors, while it is not an approved therapeutic product. Identity and purity statements therefore rest on certificates of analysis, ideally issued by an independent laboratory.
In this theory, the arms and tentacles of cephalopods look similar to the head appendages of gastropods, suggesting that they might be homologous structures. Cephalopod appendages surround the mouth, so logically they could be derived from embryonic head tissues. However, the "Arms as Foot" hypothesis, proposed by Adolf Naef in 1928, has increasingly been favoured; for example, fate mapping of limb buds in the chambered nautilus indicates that limb buds originate from "foot" embryonic tissues.
Alternatively, in Australia Under the Family Law Act 1975 (Cth), a "stepparent" in relation to a child is interpreted as a person who is not a parent of the child and is, or has been, married to or a de facto partner of a parent of the child, and treats, or at any time while married to or a de facto partner of the parent treated, the child as a member of the family formed with the parent. If one member of the couple has prior children but the couple have another child together, the complex/blended designation replaces the "simple" designation upon the birth of the new child. Any subsequent child born to the couple is a half-sibling of the respective members' prior children.
== History == Its existence was first suggested in 1905 by the British physiologist John Sydney Edkins, and gastrins were isolated in 1964 by Hilda Tracy and Roderic Alfred Gregory at the University of Liverpool. In 1964 the structure of gastrin was determined.
Sources: en.wikipedia.org
== External links == Overview of all the structural information available in the PDB for UniProt: P46937 (Human Transcriptional coactivator YAP1) at the PDBe-KB. Overview of all the structural information available in the PDB for UniProt: P46938 (Mouse Transcriptional coactivator YAP1) at the PDBe-KB.
Calendula arvensis (Vaill.) L. – field marigold, wild marigold Calendula denticulata Schousb. ex Willd. Calendula eckerleinii Ohle Calendula incana Willd. Calendula incana subsp. algarbiensis (Boiss.) Ohle Calendula incana subsp. maderensis (DC.) Ohle – Madeiran marigold Calendula incana subsp. maritima (Guss.) Ohle – sea marigold Calendula incana subsp. microphylla (Lange) Ohle Calendula lanzae Maire Calendula maritima Guss. - sea marigold Calendula maroccana (Ball) Ball Calendula maroccana subsp. maroccana Calendula maroccana subsp. murbeckii (Lanza) Ohle Calendula meuselii Ohle Calendula officinalis L. – pot marigold, garden marigold, ruddles, Scottish marigold Calendula palaestina Boiss. Calendula stellata Cav. Calendula suffruticosa Vahl Calendula suffruticosa subsp. balansae (Boiss. & Reut.) Ohle Calendula suffruticosa subsp. boissieri Lanza Calendula suffruticosa subsp. fulgida (Raf.) Guadagno Calendula suffruticosa subsp. lusitanica (Boiss.) Ohle Calendula suffruticosa subsp. maritima (Guss.) Meikle Calendula suffruticosa subsp. monardii (Boiss. & Reut.) Ohle Calendula suffruticosa subsp. tomentosa Murb. Calendula tripterocarpa Rupr.
=== United Fruit Co. and United Brands Company subsidiary === In 1963, the company was sold again, followed by another sale in 1967 to the United Fruit Co. conglomerate. AMK Corporation purchased United Fruit in 1970. Then AMK formed United Brands Company to hold A&W. In 1971, A&W Beverages Inc.—a beverage subsidiary—began supplying bottled A&W products to grocery stores. The bottled products would become available nationally. In 1972, A&W's Canadian division was sold to Unilever. A&W attempted to open restaurants in mainland Japan in the early 1970s, specifically in Fukuoka prefecture and the regions of Kanto and Kansai. The chain's performance on the mainland was sluggish in contrast to Okinawa due to several factors, such as the 1973 oil crisis, prompting the chain to withdraw from the market. A&W's Japanese operations are still handled from Okinawa. There were further fruitless attempts to bring the chain to the mainland: in the 1980s, the Okinawan branch briefly attempted to open restaurants in Kagoshima Prefecture but ended up limiting itself to Okinawa, while in the 2000s a pilot restaurant existed in Tokyo, which was quickly withdrawn. 1978 saw the introduction of a standard menu for use in all restaurants in the USA. In the 1970s, A&W had more stores than McDonald's, with a peak in 1974 of 2,400 units.
Sources: en.wikipedia.org
Usually not, though usage overlaps. The label most often refers to a short acetylated fragment of the parent protein, while thymosin beta-4 itself is the full 43-residue molecule. Because suppliers vary, a sequence statement is needed to settle the question for any particular lot.
The name is a commercial label rather than a systematic chemical designation, so different vendors and papers attach it to different sequences. Some treat it as a fragment and others as the whole protein. Comparing two reports therefore requires checking what each one actually analyzed.
Typically it reflects the relative area of the main peak in a reversed-phase chromatogram at a given wavelength. It does not confirm the amino acid sequence, the counter-ion, or the amount of peptide by mass. Identity is normally established by a separate mass measurement.
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.